Do I Sand The Wood Floor After The Slurry Seal

All wood floors are protected by a clear coating that eventually becomes scratched scuffed and dull.

Do i sand the wood floor after the slurry seal.

You do not want to seal wood that is wet or tacky in any way. Sanding sealers dewaxed shellac and wipe on finishes will all do the trick. Follow the grain of the wood. The key is to apply a thin base coat to partially seal the wood before wood staining.

Make sure you remove any sanding dust from the surface. Make sure you sand the wood well before applying stain. Should you be sealing your wood before you stain or after. Select a stain that won t raise the grain of the wood or you ll have to sand the floor after applying the finish.

Start with 80 grit to remove big scratches and imperfections then move up to 120 and finally 220 grit. Use patience so you only have to apply a. How long to wait before sealing stained wood. When a wood floor loses its luster the usual solution is to sand it down to raw wood and completely refinish it.

Sanding will also help open up the pores of the wood so that they can absorb stain better. Refinishing hardwood floors is the right solution. I like to wait 24 48 hours to let the stain dry before sealing. In general gel or heavy bodied stains work best.

Some types of stain perform better than others on blotch prone wood. If you seal it while it is sticky it may never get fully dry and hard. Rough sand the floor sanding eliminates scratches and stains from a hardwood floor but may not be able to alleviate the deepest gouges or discolored patches of wood. If it it very cold hot or humid wait up to 72 hours.

Floor finishes can emit harmful vapors so be sure the area is well ventilated as you work. Once the protective layers of sealer have been removed you continue to sand the hardwood to remove any scratches nicks or other imperfections. Typically you would do this with a drum floor sander a large piece of equipment you can rent from home improvement stores. Once you have a layer of finish on the floor any time you sand and tack the floor you will need to use a damp tack rag just dampen a cloth microfiber cloths work particularly well with the solvent that matches your finish water for waterbornes.

Allow to dry for one hour. It s time to answer one of those questions that confuses a lot of people. But often that s the wrong solution. I hope this video clear.

Try to apply as even a coating as possible. Any scratches will be enhanced by stain.